Nov 202012
 

Part 5 – Threading The Machine

This video will show you how to thread the sewing machine.

Okay, the next step is to insert it if it’s not already there. The top part of the needle is wide and flat on one side. There is a small screw that needs to be loosened in order to place the needle up through the groove, flat side facing the back. Tighten the screw and you are ready to thread the needle.

Next, place the spool of thread on the back thread spool spindle. Make sure the thread is going counter-clockwise.

Now, not all sewing machines are exactly the same, but the principle is the same. Most manufacturers place a diagram on the machine to follow. This video will show you the basics, but make sure you refer to your manual to make sure you are doing it right.

You will guide the thread, along the guide marks, up and down and, finally, through the needle. You will probably need to cut the thread to make sure it’s not frayed so that it will be easier to thread the needle. Sometimes it helps to place your finger behind the needle so you can see the hole. Then, while holding the thread between your other fingers, push the thread through the hole.

This video was created by Niler Taylor and placed on YouTube with embedding enabled. Visit her Playlist on YouTube.com.

You might find the following posts to be very helpful:

Bestselling Sewing Books.

Sewing Accessories & Supplies.

Scissors & Cutting Tools.

Happy Sewing! Continue reading »

Nov 192012
 

Part 4 – Winding The Bobbin

This video shows how to thread and wind the bobbin.

Before we can start sewing, we must thread the machine. This involves threading the upper thread and the lower thread. The upper spool of thread, when threaded through the needle, is what creates the stitches on the top side of the fabric. The bobbin thread, when picked up and pulled through the hole to join the upper thread, is what creates stitches underneath the fabric.

The first step is to wind the bobbin. This is done by placing the bobbin on the top bobbin pin, then taking the thread from the thread spool pin and winding it around the bobbin. When the bobbin is pressed against the bobbin winder, you can now wind the bobbin with thread. Refer to the operator’s manual to see if you need to release the knob inside the wheel in order to stop the needle from going up and down. Some machines automatically stop the needle when winding the bobbin, others have to be manually adjusted.

Then, press the pedal and the bobbin will start turning. The harder you press the pedal, the faster the bobbin will spin. When the bobbin is completely full, it will stop automatically. You will then remove the bobbin and cut the bobbin thread from the spool thread. You will need to lock the wheel knob again, if that’s how your machine works.

This video was created by Niler Taylor and placed on YouTube with embedding enabled. Visit her Playlist on YouTube.com.

You might find the following posts to be very helpful:

Bestselling Sewing Books.

Sewing Accessories & Supplies.

Scissors & Cutting Tools.

Happy Sewing! Continue reading »